A piezoelectric injector was modeled, in this Master Thesis Project which was carried out at Scania CV AB in Södertälje, in GT-Fuel. GT-Fuel is simulation program from Gamma Technology.The simulation model for the piezo injector was divided into a hydro-mechanical system and an electrical system (Piezoelectric element). First the hydro-mechanic model was duplicated from Advance Continuous Simulation Language model (ACSL). The simulation results were then compared to the ACSL, to verify that the hydro-mechanical system was modeled correctly. The simulation results for the electrical model were also compared with a Simulink model.

This report describes a thesis done at the Jönköping University of Technology. The aim of this thesis was to create conditions to optimize an existing automatic electrostatic coating system by changing the technology for dispensing lacquer. To select the technology, a study of different dispensing techniques carried out which concluded that the piezoelectric membrane and electrostatic atomization are the most interesting techniques.In order to perform tests with dispensing techniques a demonstrator has been optimized. The controller and PC software of the demonstrator has been programmed to be able to send out PWM signals that control the dispensers. An adapter card was designed to control the piezoelectric membrane and a steering link to the electrostatic atomization has been developed for PWM signals up to 500V.The work has laid ground for a demonstrator where further testing of the dispensing technologies can be performed..

Piezoelektriska material används flitigt i olika sensorer då de kan generera en mätbar elektrisk signal vid tryck eller töjning. Arbetet utreder hur ett piezoelektriskt garn innehållandes Polyvinyldiflourid (PVDF) påverkas av faktorer som långvarig mekanisk deformation, fukt och värme. Fokus har legat på det piezoelektriska garnets egenskaper men projektet undersöker också hur integrering i tyg samt applicering i en textil produkt fungerar. Det piezoelektriska garnet har utsatts för ett stort antal tester. I de flesta tester har proverna utvärderats genom cyklisk deformation i en extensometer.

This bachelor thesis is about an ultrasonic sensor, implemented in a bubble chamber in Artis. The sensor consists of the piezoelectric sensor and an electronic control circuit. The control circuit consists of a programmable microprocessor, PIC18F2420 and a circuit, which sends the excitation signal to the piezoelectric sensor, and later receives the echo. This bachelor thesis consists also of a theoretical study, which examines different techniques of liquid level sensing in a chamber. The study discusses which factors are important in liquid level sensing and examine accepted methods.